Page 1 of 1

Anti-Wallhack (Anti-pak2)

Posted: Fri Jan 18, 2008 9:11 pm
by gulliver-trans
So are we going to get anti-wallhack for the FvF server?

http://www.quakeone.com/forums/showthread.php?t=3171

Re: Anti-Wallhack (Anti-pak2)

Posted: Fri Jan 18, 2008 10:17 pm
by Joao Lucas
Is it really needed? 99% of the time we play Coop...

Re: Anti-Wallhack (Anti-pak2)

Posted: Sat Jan 19, 2008 12:05 am
by gulliver-trans
Needed for what?

Re: Anti-Wallhack (Anti-pak2)

Posted: Sat Jan 19, 2008 12:12 am
by Armaphage
I haven't done any testing, but I suspect it might help with my lag, because it does not send as much unnecessary information to the clients.

I also think it'd just be a good idea, unless it's for some reason less reliable or causes problems with co-op. This is probably one of the only servers running co-op, so I'd be surprised if the anti-wallhack server was tested in this mode. Someone needs to test the server out on a local network first.

Re: Anti-Wallhack (Anti-pak2)

Posted: Sat Jan 19, 2008 11:43 am
by Baker
Anti-wallhack isn't really necessary for coop.

BUT

On the topic of anti-lag, the basic anti-wallhack is not going to help with lag because it only pre-screens players. That isn't going to be significantly helpful for low bandwidth connections.

However, Rook's new engine code uses FULL pre-screening. This could significantly save bandwidth for dialup users and such, especially on the type of maps that coop is played on where very things are actually in view.

That could make a big difference AND it really does need some testing on a server running a more challenging scenario like FVF. Clan Arena and other deathmatch mods don't have a lot of non-player entities compared to coop that have them all over the place.